Please wait while we load the assembly instructions...
Parts List:(Mouseover to highlight)
- 1 Fabric Mat
- 2 long & 2 short pieces 1/4" plastic tubes. (Not needed for 40 oz. solid vinyl fabric.)
- 2 long & 2 short lengths frame pipe
- 4 leg pipes
- 8 machine screws & 8 locknuts
- 4 top corners
- 4 bottom corners
- 4 leg bottom inserts
Step 1Lay fabric flat with underside facing up and insert the plastic tubes into sleeves.
(Stitched side up)
Step 2Insert fabric sleeves into the channel on each length of pipe.
Step 3Working from underneath, position one top corner fitting and insert bolt through fitting and pipe. Place a bottom fitting in position, secure with lock nut and hand tighten. Insert and secure second bolt. Repeat process at other three corners.
44 x 27 and 50 x 35 beds have reinforcing pips that may shift inside frame during shipping and block a bolt hole. tape frame on floor or use a hammer & screwdriver to center the pipe between holes.
Step 4Place an insert into the bottom of each leg. Turn bed right side up and tighten screws and nuts.
Note: Tighten properly -- correct tightening will leave end of bolt flush with the nuts' white nylon locking material. Insufficient or over tightening of the corners may result in cracking.
Assembly instructions are available for download by clicking the following:
Standard Instructions
Aluminum Bed Instructions
Cat Tower Instructions:
2 tier cat tower
3 tier cat tower
4 tier cat tower
5 tier cat tower
6 tier cat tower
7 tier cat tower
8 tier cat tower
9 tier cat tower
Adobe PDF Reader required for viewing. Click here to download.
Free shipping on all orders of $20 or more!
